Configure The Settings Relating To The Mail Notification [E-Mail] - Panasonic WJ-NX400K Operating Instructions Manual

[Setup via recorder's main monitor]

Configure the settings relating to the mail notification [e-Mail]

The settings of alarm mail notice, the settings of error report mail (☞ Page 190) and the settings to use the
mail functions can be configured on this tab.
[SMTP server address]
Enter an IP address or a name of the SMTP server to
send e-mails. The name of the SMTP server is availa-
ble only when "Manual" is selected for "DNS" on the
[Basic] tab accessed from the "Advanced setup"
menu - the "Network" page of the setup menu. Enter
up to 255 alphanumeric characters including hyphens
(-) and periods (.).
[SMTP port number]
Enter the port number of the SMTP server.
1 - 65535
Default: 25
[POP server address]
Enter an IP address or name of the POP server to be
used for POP before SMTP authentication. The name
of the POP server is available only when "Manual" is
selected for "DNS" on the [Basic] tab accessed from
the "Advanced setup" menu - the "Network" page of
the setup menu. Enter up to 255 alphanumeric char-
acters including hyphens (-) and periods (.).
[Authentic method]
Select the authentication method to send e-mails
from the following.
None/ POP before SMTP/ SMTP
Default: None
[Authentic method - User name]
Enter the user name to be required for the authentica-
tion. Enter up to 32 alphanumeric characters exclud-
ing "&" listed in the description of "Note".
[Authentic method - Password]
Enter the password to be required together with the
user name for the authentication. Enter up to 32
alphanumeric characters excluding "&" listed in the
description of "Note". An entered character for the
password will be displayed as "*" or "•".
Note:
• Available characters are as follows.
A B C D E F G H I J K L M N O P Q R S T U V W X
Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9 ! # $ % &' ( ) * + ,- . / : ; < = > ?
@ [ ¥ ] ^ _ ` { | } ~
[Sender's address]
Enter the mail address of a sender. Entered mail
addresses will be displayed in the "From" (sender)
line. Enter up to 127 alphanumeric characters includ-
ing hyphens (-), periods (.), @, and _.
Default: NWDR
[Security]
Alarm mails or error report mails will be encrypted
and transmitted. Authentication method will be set to
"SMTP" if it is not set to "Off". Set the user name and
password for the authentication.
Off, SMTP over SSL, STARTTLS
Default: Off
[Destination address - Address1 - Address4]
Enter the mail addresses of the recipients of the alarm
mail and the warning mail (☞ Page 190). Enter up to
255 alphanumeric characters including hyphens (-),
periods (.), @, and _.
Check the desired mail type (Warning/Alarm) to be
sent.
Up to 4 destination addresses can be registered.
53