Panasonic WJ-NX400K Operating Instructions Manual page 143

[Operation via recorder's main monitor]
Step 5
Enter the password, and then click the [Next] button.
For character entry, refer to "About the operation of
on-screen keyboard" (☞ Page 100).
• Enter 5 to 8 alphanumeric characters for a pass-
word.
• To confirm the password, enter the same pass-
word again into the "Retype" column.
• To save the entered password, check "Memorize
password temporarily". The next time data is cop-
ied, the password entry window will open with the
password already filled in. The password will be
retained in memory until the power of the recorder
is turned off.
→ The copy start confirmation window will be dis-
played.
Step 6
Click the [OK] button in the copy start confirmation
window.
→ Switches to the copying window and displays
copying progress.
Important:
• Do not disconnect the external storage device
when copying is being performed. Otherwise the
data stored on the SD memory card or the exter-
nal storage device could be lost.
• If the copy destination lacks sufficient remaining
storage capacity, copying will continue until the
medium is full. Use a medium with sufficient stor-
age capacity to avoid left over data that is not
copied.
• Copying will be performed in the following order:
Viewer Software → Images → Audio Depending
on the designated time range for copying and the
remaining space of the storage medium, images
and audio may not be copied.
• Clicking the [Copy] button during the copying pro-
cess will display the copying window. Clicking the
[Cancel] button will display the copy cancel confir-
mation window. Copying continues while the copy
cancel confirmation window is displayed.
• Do not turn off the power of the recorder while
copy is in progress. If the power is turned off while
copying, the storage media copied on will become
unusable.
• Recorded images (data) of up to 1 million can be
copied onto the external device connected to the
copy port "COPY". However, it is impossible to
copy any more data exceeding these limits even
when there is a sufficient remaining capacity.
• Due to characteristics of the file system, the copy-
ing time becomes longer as the number of record-
ing data copied to the external storage device at
one time increases. To copy a massive number of
files, keep the number of files to handle at one
time less than 10000. And every time the copy is
finished, it is recommended to disconnect the
memory device and connect it again.
• The progress of the copy is calculated based on
the size displayed as "Data size". If copying more
than 10000 files, correct value will not be dis-
played.
Step 7
Once the copying process is completed, the copy
complete window will be displayed. Click the "Close"
button and remove the external storage device.
Note:
• Usage time varies depending on the capacity of
the USB medium or the recording content. Retry
again later if you fail in operation.
143