Configure The Network Settings; Configure The Network Settings Of The Recorder; Configure The Network Settings Of The Pc - Panasonic WJ-NX400K Operating Instructions Manual

[ Setup Network ]

Configure the network settings

The recorder can be operated using a mouse or from a web browser on a PC (excluding certain functions and
settings). On the following pages, operation from a web browser, setting up the PC and related matters will be
described.
When operating the recorder using a web browser, it is necessary in advance to configure the network settings
of the recorder and a PC.
When the network settings of the PC are as follows, it is unnecessary to configure the settings. It is possible to
configure the settings and operate the recorder using a web browser after completing the connection.
IP address: 192.168.0.2 - 192.168.0.249, 192.168.0.251 - 192.168.0.254
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.1
When the settings are configured differently from the above, configure the network settings of the recorder or a
PC.

Configure the network settings of the recorder

The network settings of the recorder can be configured on the [Basic] tab of the "Network" page under the setup
menu [Advanced setup].
Refer to the chapter relating to the [Basic] tab of "Network" of the setup menu on page 49 for how to operate.

Configure the network settings of the PC

The TCP/IP setting of the PC shall be changed to conform to the settings of the recorder. When using the
recorder with the default (IP address:192.168.0.250), set the IP address of the PC to "192.168.0.xxx (a number
from 2 to 254 except 250 (this recorder))".
The settings described in these operating instructions are based on the standard settings for Windows 7. Refer
to the operating instructions of the respective OS for further information.
Important:
Step 1
• Log in to the PC as an administrator.
Click "Control Panel" on the start menu.
→ "Control panel" will be displayed.
150