Advertisement
2) Glue servo into rudder with foam safe glue. If you opted for adding rudders,
you would have pre-installed servo leads into the booms in step 1 of General
Assembly.
3) For equipment cutouts in the wing, if you do not plan to use, suggest gluing
in place or securing with tape.
Plywood FPV Tray
1) Plywood FPV Tray (PNP version) works with the 480TVL Sony CCD FPV
camera. Requires medium CA glue for assembly.
9
2) Glue tray doubler to bottom of main tray piece. Make sure the camera cut
out is oriented, so the large cable cut out is on the left as shown. (bottom view)
3) Glue camera doubler to top of main tray. Align with camera hole on main tray.
4) Glue guide rails and cross member in place. Camera should slide into hole
as shown. The retainer plate can be screwed in place or glued.
5) Glue magnet to bottom of tray, orienting the magnet pole relative to the
foam canopy tray.
Advertisement
