Parking The Machine; Filling In Fuel; Information And Safety Stickers/Decals On The Machine - Bomag BT 60/4 Operating Instructions Manual

Parking the machine

Stand the machine on ground as level as possible.
Before leaving the machine:
Secure the machine against tipping over.
G

Filling in fuel

Refuel only with the engine shut down.
Do not refuel in closed rooms.
No open fire, do not smoke.
Do not spill any fuel. Catch running out fuel, do not
let it seep into the ground.
Do not inhale any fuel fumes.
Avoid contact with skin and eyes.
Do not swallow.
Maintenance
Maintenance work must only be carried out by
qualified and authorized personnel.
Keep unauthorized persons away from the ma-
chine.
Do not perform maintenance work while the en-
gine is running.
Park the machine on level and firm ground.
Working on the fuel system
No open fire, do not smoke, do not spill any fuel.
Catch running out fuel, do not let it seep into the
ground and dispose of environmentally.
Do not breath in fuel fumes.
Working on the engine
When working on the fuel filter make sure that no
dirt falls into the air channel.
Do not work on the hot exhaust, risk of burns!
When working on the exhaust channel of the en-
gine make sure that no combustion residues fall
into the cylinder.
Do not touch the piston with the cleaning tools.
Working on the tamper foot
Wipe off spilled oil, catch running out oil and dis-
pose of environmentally.
Store oily material in a specially marked container
and dispose of environmentally.
Cleaning
Do not clean the machine while the engine is run-
ning.
Do not use gasoline or other inflammable sub-
stances to clean the machine.
When using steam cleaning equipment do not
subject electric parts and insulating material to the
direct water jet or cover them beforehand.
Do not guide the water jet directly into the air filter,
into the exhaust or into the air intake opening.
After the maintenance work
Reinstall all protective devices after completing
maintenance.
Repair
Repairs must only be carried out by qualified and
authorized personnel. Always follow our repair in-
structions.
Exhaust gases are highly dangerous! Always en-
sure an adequate supply of fresh air when starting
in closed rooms!
Attach a warning tag to the steering bow if the ma-
chine is defective.
Do not mix the nozzle in the carburettor up by
G
mistake.
Adjust the idling speed regulator screw exact-
G
ly.
Do not damage the blower wheel when work-
G
ing on the magnetic ignition.
Always replace self locking nuts.
G
Do not open the foot cover on the tamper foot,
G
spring tension. Danger of accident!
Observe the prescribed tightening torques.
G
Information and safety stickers/decals
on the machine
Keep safety stickers in good and legible condition
(see parts manual) and comply with their meaning.
Replace damaged and illegible stickers/decals.
BT 60/4, BT 65/4