Bomag BT 60/4 Operating Instructions Manual page 28

4.6 Changing the tamper foot
plate
Fig. 27
After changing the tamper foot plate (Fig. 27)
G
tighten the 4 fastening screws with a tightening
torque of 60 to 70 Nm (44 to 52 ft.lbs).
i Note
When changing the tamper foot to a different width
use only genuine BOMAG parts.
After changing the tamper foot check the engine
speed, adjust it if necessary.
4.7 Loading/transport
Danger
Danger of accident!
Always shut the engine down to transport the
tamper or to lay it on its side.
Make sure that persons are not endangered by
the machine tipping or sliding off.
Lash the machine down, so that it is secured
against rolling, sliding and turning over.
For lifting the machine attach the lifting gear
only to the cross strut of the steering handle.
The machine should not swing about when be-
ing lifted.
Do not stand or step under loads being lifted.
Use only safe lifting gear of sufficient load
bearing capacity Minimum lifting capacity of
lifting gear: see operating weight in chapter
"Technical Data".
Fig. 28
Always shut the engine down to transport the
G
tamper or to lay it on its side.
Lay down the tamper (Fig. 28) to transport it on
G
the rollers.
BT 60/4, BT 65/4