Setting The Machine Type - Bomag BW 154 AP-4 Manual

Service Training BW 154/174-4 AP
7.3

Setting the machine type

Since the same control can be used for all pivot steered tandem rollers, the machine type must be
adjusted during the initial installation or in case of a replacement. This setting of the machine type is
necessary, even though the functions of the machines are identical, but not the valves, hydraulic
pumps, hydraulic motors etc. When adjusting the machine type all settings required for the respective
machine type are made.
For easier control of the adjusted machine type the respective machine type appears in the display
module for 3 seconds whenever the ignition is switched on. The following table shows the assignment
of the various machine types to the machine codes.
The range of serial numbers must be strictly observed!
Machine type
BW 154 AP
BW 154 ACP
BW 154 AP AM
BW 154 ACP AM
BW 174 AP
BW 174 AP
BW 174 AP AM
BW 174 AP AM
Do not operate a machine with incorrect type setting, because this could lead to unacceptably
long braking distances and very abrupt movements!
After replacing a control always compare the machine type set on the control with the actual
machine type and correct the setting, if required!
Status: 25. November 2010
Author: H.Mueller, VK
First serial number
101 870 61 2001
101 870 63 2001
101 870 60 2001
101 870 62 2001
101 870 71 1001
101 870 71 1007
101 870 70 1001
101 870 70 1050
Functions of the ESX control
Last serial number
101 870 61 xxxx
101 870 63 xxxx
101 870 60 xxxx
101 870 62 xxxx
101 870 71 1006
101 870 71 xxxx
101 870 70 1049
101 870 70 xxxx
Machine type code
7320
7321
7325
7326
7350
7352
7355
7357
Page 11 of 38