Distribution Zones - Siemens Synco700 RMK770 Documentation Handbook

Controller 2
T
4
T
Generation zone
Boiler 4
(b.-address 4)
190/226
Building Technologies
HVAC Products
RMK770
T
3
T
Boiler 3
(b.-address 3)
The boiler sequence manager is always in the controller with the main flow sensor.
Usually, boiler 1 is also controlled by the controller with the main flow sensor.
Normally, boiler 1 is assigned boiler address 1, boiler 2 boiler address 2, etc.
In normal situations, no changes are required here.
When, in the above example, boilers 1 and 2 are assigned to the first RMK770, boilers
3 and 4 of the second RMK770 should also be called boilers 3 and 4. Hence, they are
automatically given boiler addresses 3 and 4 and appear as boilers 3 and 4 on the info
level of the controller with the boiler sequence manager.
If, on the second RMK770, one would have used boilers 1 and 2 and assigned to them
boiler address 3 and 4 in Setting > Communication > Generation zone, the RMK770 with the
boiler sequence manager would have displayed the boilers as boilers 3 and 4, but they
would have been displayed as boilers 1 and 2 on the second RMK770.
13.3

Distribution zones

T
T
2
1
T T
Boiler Sequence Controller RMK770
13 Communication
Controller 1
RMK770
T
T
2
1
T
T
T
Boiler 2 Boiler 1
(b.-address 2) (b.-address 1)
T
T
Controller 3
RMH760
T
T
Heat
consumer
Boiler
seaquence
manager
Wärmeverteilzone
Vorregler
Wärmeverteilzone
Hauptverteiler
Controller 4
RMH760
T
Heat
consumer
Heat distribution zone
CE1P3132en
01.03.2005