Table of Contents
Advertisement
4.2 Testing "Serial to Ethernet" Function
STEP1: Connect the power to the WIZ110SR board.
STEP2: By using Configuration Tool program, set the board.
STEP3: Run a Hyper Terminal or any other terminal emulator.
STEP4: Set the baud rate with same value of WIZ110SR.
STEP5: Run one more Hyper terminal, and set the IP address and port number by using TCP/IP
(Winsock)
STEP6: Type some characters at the Serial Hyper Terminal screen. For example input
"01234567890".
STEP7: Check if above characters are displayed at the Network Hyper Terminal opened at the
STEP 5. (Serial -> Ethernet)
STEP8: Input any character at the Network Hyper Terminal and check if it is displayed at the
Serial Hyper Terminal screen. (Ethernet -> Serial)
* Above function can be tested through Device Terminal Program that WIZnet is providing. The
program
is
downloadable
at
the
Library
page
of
WIZnet
homepage
(http://www.wiznet.co.kr/support_download.htm). By using Device Terminal program, the
data communication between serial and Ethernet can be easily and simply tested.
Copyright © WIZnet All Rights Reserved
ASRB for SERIAL | 20 page
Advertisement
Table of Contents
