Sway Bar (F-Series/T-Series/Z1) - Arctic Cat Sno Pro 120 2011 Service Manual

2. Remove the lock nuts and cap screws securing the
sway bar arms to the sway bar; then remove the
arms. Pull the sway bar out and account for two bear-
ings.
INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Inspect the sway bar for any signs of twisting,
fatigue, or wear.
2. Inspect the sway bar arms for cracks or damage.
3. Inspect the links, bushings, bushing retainers, and
hardware for damage or wear.
INSTALLING
Key
1. Washer
2. Washer
3. Lock Nut
4. Cap Screw
5. Cap Screw
6. Lock Nut
7. Link
8. Cap Screw
9. Lock Nut
10. Sway Bar
11. Bearing
12. Arm
1. Place the sway bar into position; then install a bear-
ing on each end of the sway bar.
2. Slide the sway bar arms onto the sway bar until the
holes in the arms align with the notches in the sway
bar. Install the cap screws and lock nuts. Tighten
securely.
 NOTE: Make sure the arms are positioned on the
same flat on both ends of the sway bar.
3. Place the links into position on the sway bar arms;
then secure with cap screws and lock nuts.
Sway Bar
(F-Series/T-Series/Z1)
REMOVING
1. Remove the two lock nuts securing the sway bar
mounting brackets to the chassis; then using a soft
hammer, tap the sway bar in either direction until the
sway bar link is off the pin on the A-arm.
2. Slide the sway bar out of the chassis and account for
the sway bar links and four sleeves.
INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Inspect the sway bar for any signs of twisting,
fatigue, or wear.
2. Inspect the sway bar links for cracks or damage.
INSTALLING
1. Place the sway bar into position in the chassis; then
install the sway bar links to each end of the sway bar
and position the links onto the pins of the A-arms.
2. With the sway bar properly positioned in the chassis,
736-034A
install the sleeves onto the sway bar. Install the sway
bar mounting brackets and secure the brackets with
the lock nuts and tighten to 120 in.-lb.
Front Suspension
Mounting Bracket
(Bearcat/F-Series/T-Series/
 NOTE: On the liquid-cooled F-Series to remove the
front suspension mounting bracket, it will be neces-
sary to remove the air silencer. Proceed to Air
Silencer (Liquid-Cooled F-Series 2-Stroke) sub-sec-
tion in Section 3 and follow REMOVING procedure.
REMOVING
 NOTE: For the following procedure, refer to illustra-
tion on the following page.
1. Elevate the front of the snowmobile with a suitable
safety stand or lift.
 NOTE: Steps 2-5 are for the Z1 only.
2. Remove the hood; then remove the self-tapping
screws securing the front bumper assembly to the
left-side and right-side panels.
Manual
Table of Contents
0744-929
Z1)
8-27
8