Arctic Cat Sno Pro 120 2011 Service Manual page 500

 NOTE: To aid in removing the tie rod cap screws
from the drag link, position the drag link so the cap
screw is aligned with the opening between the skid
plate and the suspension mounting bracket.
4. Remove the cap screws and lock nuts (C) from the
steering arms (D); then remove the drag link and
steering arms from the suspension mounting bracket.
5. Secure the drag link in a suitable vise; then remove
the cap screws and lock nuts (E) securing the steer-
ing arms to the drag link. Remove the arms and
account for the axles (F) inside the steering arms.
 NOTE: With the steering arms removed, note the
direction of the steering arms for installing purposes.
6. If replacing using a suitable punch, drive the two
bearings out of the drag link.
8-10
0741-924
INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Inspect the entire drag link (especially in the areas
where the ball joints attach) for any signs of cracks,
wear, or damage.
2. Inspect the bearings and axles for wear or damage.
INSTALLING
1. If the bearings were removed, place the drag link in a
suitable vise and press the bearings into the drag
link.
ZJ159A
2. Secure the steering arms to the drag link with the
drag link axles, cap screws (E) (threads coated with
blue Loctite #243), and new lock nuts (E). Tighten to
12 ft-lb (Bearcat/F-Series/T-Series) or 120 in.-lb
(Z1).
ZJ161A
Manual
Table of Contents
ZJ162
ZJ163A
0741-924