Calibration - B&G Triton2 Operator's Manual

• Select data: Used for defining which data that should be
displayed on the selected HV display
• White backlight: Sets the the backlight to white
Ú Note:
This option is not available for the 40/40 HV display
• Display group: Sets the network group for the unit
• Instance: Sets the network instance for the unit
For more information about network groups and instance settings,
refer to "Network" on page 69.

Calibration

Ú Note:
Once the unit is setup and before you proceed with
calibration ensure all network sources are selected and
configured. Refer to "System settings" on page 69.
Boat speed
Speed calibration is necessary to compensate for hull shape and
paddlewheel location on your boat. For accurate speed and log
readings, it is essential that the paddlewheel is calibrated.
SOG reference
This is an auto calibration option that uses speed over ground (SOG)
from your GPS, and compares the average of SOG against the
average boat speed from the speed sensor for the duration of the
calibration run.
Ú Note:
This calibration should be made in calm sea with no
effect from wind or tidal current.
Software setup | Triton2 Operator manual
61