Status Display; Local Operation; Control Elements For Local Operation - Siemens SITRANS P DS III Operating Instructions Manual

Operation

6.5 Local operation

6.4.5

Status display

Description
The arrows of the status display have a different meaning depending on the mode setting.
The table below shows the meanings of the arrows in the respective functions.
Meaning
Table 6- 3
Function
Measured value display
Adjusting damping
LO calibration
HI calibration
Alarm
Warning
See also
Overview of status codes (Page 185)
6.5 Local operation
6.5.1

Control elements for local operation

Introduction
You operate the transmitter on site using the buttons. You can select and execute the
functions described in the table using adjustable modes. Operation by buttons is not
available for devices without display.
76
Meaning of the arrow displays
Mode
4
19
20
Display
Pressure exceeds the upper
sensor limit.
Exceeds the upper damping
value
–
Calibration span too high
Upper alarm limit reached
Upper warning limit reached
Operating Instructions, 06/2013, A5E00053276-07
Display
Pressure falls below the lower
sensor limit.
Falls below the lower damping
value
Calibration span too low
–
Lower alarm limit reached
Lower warning limit reached
SITRANS P DS III with PROFIBUS PA