Installation For Level - Siemens SITRANS P DS III Operating Instructions Manual

Note
Protect the transmitter from:
• Direct heat
• Rapid temperature changes
• Severe soiling
• Mechanical damage
• Direct sunlight
Note
Select the height of the mounting flange such that the pressure transmitter is always
mounted below the lowest fill height to be measured.
The installation location is to be as follows:
● Easily accessible
● The measuring point must be as close as possible
● Vibration-free
● Within the permitted ambient temperature values
4.4.2

Installation for level

Note
Seals are required for the installation. The seals must be compatible with the medium to be
measured.
Seals are not included in the delivery.
Procedure
To install the transmitter for level, proceed as follows:
1. Attach the seal to the container's mating flange.
2. Screw on the transmitter's flange.
3. Observe the installation position.
SITRANS P DS III with PROFIBUS PA
Operating Instructions, 06/2013, A5E00053276-07
Ensure that the seal is centrically positioned and that it does not restrict the movement of
the flange's seal diaphragm in any way as otherwise the tightness of the process
connection is not guaranteed.
Installing / mounting
4.4 "Level" installation
49