Miele PG8582 CD Operating Instructions Manual page 154

Plumbing
AD water
connection for
30-1.000 kPa (UK:
200-1,000 kPa)
pressure -
pressure-
resistant
Demineralised
water ring line
IMPORTANT
154
This washer-disinfector is supplied as standard for a pressurised
system operating between 30-1.000 kPa (UK: 200-1,000 kPa). If the
water pressure is below 200 kPa the water intake duration will be
automatically increased.
The pressure tested hose for AD water, coded green, has a ¾ inch

threaded union for connection to the onsite stopcock for AD water.
 If the machine is not going to be connected to AD water, the AD
water connection has to be deactivated by a Miele Service
technician. The inlet hose remains in position at the back of the
machine.
The machine can be connected to a ring line system for
demineralised water. For this purpose, it must be technically adapted
and the controls reset by Miele Service.
Please contact Miele Service for further information.
UK, Australia and New Zealand.
This appliance must be installed according to AS/NZS 3500.1
(Australia and New Zealand) or in accordance with WRAS
regulations (UK). This appliance has been supplied with a separate
backflow prevention device.
This machine must be connected to the potable water supply via the
non-return valve (check valve) supplied with the machine.
Before making plumbing connections, ensure the appliance is
disconnected from the mains power supply (switch off or unplug from
the power supply).
Turn off the mains water tap.

Place the seals on both sides of the non-return valve.

Connect the female end of the non-return valve to the mains water

tap (3/4" thread).
Connect the filter to the male end of the non-return valve (3/4"

thread).
Connect the inlet hose to the filter.

Ensure that all connections are screwed into position correctly. The
connection point is subject to mains water pressure.
Turn on the tap slowly and check for leaks.

Correct the position of the seal and union if necessary.