FLIR TCX series Instruction Manual page 50

6
Setup
To configure No SD Card errors:
1. Under Event Type, select No SD Card.
2. Check Enable to enable No SD Card errors.
3. Check Relay-out to trigger an alarm out device when No SD Card errors occur.
Under Alarm Delay, enter the number of seconds before the alarm out device will be
activated.
NOTE
Relay-out is only available if your camera supports alarm output. Check the technical specifications
for your camera.
4. Check Send Email to send an email alert when No SD Card errors occur.
5. Click Save to save changes.
To configure Capacity Warnings:
A Capacity Warning occurs when the recording destination (microSD / SD card or FTP
server) reaches capacity.
To configure Capacity Warnings:
1. Under Event Type, select Capacity Warning.
2. Check Enable to enable Capacity Warnings.
3. Under Capacity Limit, set the percentage of free space on the recording destination
that will trigger a Capacity Warning. For example, if you enter 10% and your microSD
card is 1GB, a warning will occur when there is only 100MB of free space remaining.
#LX400062; r.30885/35920; en-US
42