Deleting The Measured Values - Hartmann Tensoval duo control Instructions For Use Manual

ings and evenings.
The calculated general mean value
is based on all measured values
stored for the respective person. If
only two measured values are in
memory, the mean value will be
calculated from these two meas-
ured values. If only one measured
value is in memory, this measured
value corresponds to the mean
value.
If there is no morning and/or
evening value for the last seven
days in the memory, then dashes
are displayed instead of values in
the display for morning and eve-
ning averages over the last seven
days. If no values are stored at all
in the memory, then dashes are
also displayed instead of values in
the display for the overall average.
MEMO
1
If an irregular heartbeat was
detected during measure-
ment, this information
stored and displayed when recalling
the measured values from the
device memory, together with the
systolic and diastolic blood pressure
value, the pulse rate, the time, date
and year.
You can cancel the memory's recall
of data at any time by pressing the
START / STOP button. Otherwise the
device will switch itself off auto-
matically after approx. 30 seconds.
Even if the power supply fails, e.g.
when changing the batteries, the
stored values will still be available.
5.3 Deleting the measured
values
You can delete the stored values for
and
delete all values of a user, press the
memory button of the correspond-
ing measurement memory
The morning average values over
the last seven days will be dis-
played. If you press the button
again and then hold down the
memory button for 4 seconds, the
numbers and signs except
start to flash in the display. If
you hold down the memory button
for another 4 seconds, all data for
the selected user is deleted. Now
the display either shows
If you would like to delete individ-
ual values, please call up the
corresponding individual value to
is also be deleted (see 5.2) and press the
respective memory button for 4 sec-
onds, so that the display flashes.
After pressing for another 4 sec-
onds, the respective individual
value is deleted. Now the display
either shows
135
English
separately. In order to
or .
GB
or .
and/or
or .