Hdd Extension Box - Fujitsu PRIMERGY TX300 S5 Options Manual

HDD extension box

6.4 HDD extension box
In the base units two 5.25-inch bays for accessible drives can be used to install
a HDD extension box.
Two variants of the HDD extension box are available:
HDD extension box for 3.5-inch HDD modules (Multibay 2):
Multibay 2 contains one bay for a LSP or LSD, one bay for a DVD drive, and
two bays for 3.5-inch HDD modules.
HDD extension box for 2.5-inch HDD modules:
This HDD extension box contains eight bays for 2.5-inch HDD modules.
The HDD extension box is supplied without EasyClick rails. You need 4 M3
screws. Before installing a new HDD extension box you must therefore remove
the EasyClick rails from one dummy cover and mount two EasyClick rails on the
HDD extension box.
Ê Remove the dummy covers from the required 5.25-inch bays (see section
"Equipping of the bays" on page 41
cover" on page
Ê Detach the EasyClick rails from a dummy cover by removing the four screws
on each side (see figure
I
Note that there are two M3 screws and two UNC screws on each side
figure 20 on page
V
CAUTION!
Keep the dummy covers for future use. If you remove the HDD extension
box again and do not replace it with a new one, the dummy covers must
be reinstalled to comply with EMC regulations and to satisfy cooling
requirements and fire protection measures.
58
43).
19 on page
44.
Options Guide
and section "Removing the dummy
43).
Accessible drives
TX300 S5