Lancom l-54ag User Manual page 20

LANCOM L- 54ag Wireless – LANCOM L- 54g Wireless – LANCOM IAP- 54 Wireless
Chapter 2: Installation
LAN interface: exclusive or in parallel for DSLoL
There are two principle DSLoL operation modes available. Either use the exclusive mode when
connecting your LANCOM 54 Wireless directly to a DSL modem, or use the automatic mode
when connecting the LANCOM 54 Wireless to a hub or switch of a cable-bound LAN, and
connect this hub/switch again to the DSL modem. If the LANCOM 54 Wireless is broadcasted
as gateway via DHCP, computers in LAN
and WLAN can use the internet connec-
tion simultaneously via one physical
interface. Set the desired mode in
LANconfig in the Interface settings of the
DSLoL interface.
DSLoL supports all PPPoE-based Internet access lines, as well as those that are
supplied with a access router with multiple fixed IP addresses (such as many SDSL
business lines).
Note the setting of the node/hub switch
If the node/hub switch for your application is not in the right position, no correct connection
will be established between the LANCOM 54 Wireless base station and other devices of the
cable-bound LAN and/or a DSL modem.
Antenna Aux
The node/hub switch is always in position 'node', when the LANCOM 54 Wireless base station
is connected to a network. The setting 'hub' is needed, when the base station will be directly
connected to another device like a single PC or a DSL modem.
20
your local network (resp. into a free socket of a hub/switch). In this case,
the node/hub switch
Connect to power – Connect socket
using the included power adapter.
Use the supplied power supply unit only! Using an unsuitable power
supply unit may cause damage or injury.
AC 12 V
remains in the presetting 'node' ( ).
of the unit to a power supply
Node
Hub LAN 10/100 Mb
Node/hub switch
Reset
Antenna Main