OPHIR vega User Manual page 18

2.5.2. Changing Chosen Wavelengths (metallic type
only)
1. Select "Laser" and enter.
2. Select the wavelength you wish to use and enter. If
you wish to save this wavelength as the startup
default, press "Save" before exiting.
3. If you wish to modify one of the wavelengths, select
the wavelength and press the right navigation key.
4. Using the up/down navigation keys to change the
numbers and the right/left navigation keys to move to
the next number, modify to the desired.
.
5 When finished, press "Save" and exit. To apply these
changes to this session only, exit without pressing
"Save".
2.5.3. To set type of laser being used
From main measurement screen, select "Laser" and
enter. Choose the desired laser type or wavelength. If
you want this one to be the startup wavelength, press
"Save" before exiting.
2.5.4. Setting Startup Configuration
1. Turn on the Vega with the sensor connected, select
"Menu" and enter. Select "Configure".
2. With the navigation keys select "Startup Mode",
press the Enter key and select "Power" or "Energy"
as the startup mode. Press Enter again to exit. If you
want this mode to be permanent, press Save after
pressing the Enter key.
3. Select "Display Mode". Press the Enter key and
select the type of screen you wish to start up with.
Press Save to set this as the default display mode. If
you do not want to save this as the startup mode but
only change for now, press the Enter key. (This
choice is saved in the instrument and not the sensor
so the Vega will start up from the screen selected
for all sensors).
4. Select "Energy Range" and press the Enter key.
Choose the energy range you wish to be the default.
17