Remove The Power Module; Configuration With A Field Communicator - Emerson CSI 9420 Reference Manual

2.1.11

Remove the power module

The CSI 9420 device is powered whenever the power module is installed. To avoid
depleting the power module, remove it when the device is not in use.
After you have configured the sensors and network, disconnect the communication leads,
remove the power module (if the device is not already installed), and replace the
transmitter cover. You should insert the power module only when you are ready to
commission the device.
2.2

Configuration with a Field Communicator

You can configure the CSI 9420 using a Field Communicator. Follow the connection
diagram in
A Rev 4 DD is recommended when using a Field Communicator to configure the CSI 9420.
The DD for the CSI 9420 is located on the DVD that came with the transmitter. Refer to the
Field Communicator User's Manual for more details on DDs or go to
www2.emersonprocess.com/en-us/brands/Field-Communicator/Pages/SysSoftDDs.aspx
for instructions on adding a DD for CSI 9420.
The CSI 9420 requires Field Communicator System Software version 3.2 or later.
Figure 2-4 through Figure 2-15 show the Field Communicator configuration menu trees for
CSI 9420 using a Rev 4 DD. For ease of operation, you can access some common tasks in
several locations of the menu structure.
MHM-97408, Rev 15
Figure 2-2.
Configuration
http://
19