Table of Contents
Advertisement
Replacing the display hinges
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Procedure
1
Align the screw holes on the display hinges with the screw holes on the
display back-cover and antenna assembly.
2
Replace the eight screws (M2.5x2.0L) that secure the display hinges to the
display back-cover and antenna assembly.
3
Route the antenna cables through the routing guides on the display back-
cover and antenna assembly.
4
Route the logo-board cable through the routing guides on the display back-
cover and antenna assembly.
5
Route the display cable through the routing guides on the display back-cover
and antenna assembly.
6
Place the hinge caps on the display hinges and press down to snap them into
place.
Post-requisites
1
Replace the
2
Replace the
3
Replace the
4
Replace the
5
Replace the battery.
6
Replace the
7
Replace the
8
Replace the
98
display
panel.
display
bezel.
display
assembly.
system
board.
heat-sink
assembly.
coin-cell
battery.
computer
base.
computer. After working inside your
After working inside your
computer.
Advertisement
Table of Contents
