Removing The Camera Cable; Prerequisites; Procedure - Alienware 15 R3 Service Manual

Removing the camera cable

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.

Prerequisites

NOTE: These instructions are applicable only for laptops with a non-
touch screen display.
1 Remove the
2 Remove the
3 Remove the
4 Remove the
5 Remove the
6 Remove the
7 Remove the
8 Remove the
9 Remove the battery.
10 Remove the
11 Remove the
12 Remove the
13 Remove the
14 Remove the

Procedure

1 Peel the tape that secures the camera cable to the camera module and
disconnect the camera cable from the camera module.
base cover.
wireless card.
solid-state drive.
memory modules.
rear-I/O cover.
computer base.
coin-cell battery.
heat-sink assembly.
system board.
display assembly.
display bezel.
display panel.
display hinges.
computer. After working inside your
After working inside your computer.
83