Table of Contents
Advertisement
FX
-32DP PROFIBUS-DP Interface Block
3U
User's Manual
7.
Parameter Setting and Network Configuration
[GX Configurator-DP]
STARTUP AND MAINTENANCE
PRECAUTIONS
• Do not touch any terminal while the PLC's power is on.
Doing so may cause electric shock or malfunctions.
• Before cleaning or retightening terminals, externally cut off all phases of the power supply.
Failure to do so may cause electric shock.
• Before modifying or disrupting the program in operation or running the PLC, carefully read through this manual
and the associated manuals and ensure the safety of the operation.
An operation error may damage the machinery or cause accidents.
STARTUP AND MAINTENANCE
PRECAUTIONS
• Do not disassemble or modify the unit.
Doing so may cause fire, equipment failures, or malfunctions.
* For repair, contact your local Mitsubishi Electric representative.
• Do not drop the product or expose the product to strong impacts, as doing so may cause product damage.
• Turn off the power to the PLC before attaching or detaching the peripheral devices.
Failure to do so may cause equipment failures or malfunctions.
To set the parameters and configure the DP network, use GX Configurator-DP (Ver.7.00A or later).
→ For details on DP-Master setting procedures, refer to the respective DP-Master manual
Note
Module type
Select the appropriate module type in the "Network Setup" dialog box.
Operation mode
The FX
-64DP-M PROFIBUS Master Module has 2 operation modes for cyclic communication.
3U
- The Normal Service Mode exchanges a maximum of 32Byte/Slave.
- The Extended Service Mode exchanges a maximum of 244Byte/slave.
→ For the MELSEC PROFIBUS Operation Modes, refer to the respective DP-Master manual
7 Parameter Setting and Network Configuration [GX Configurator-DP]
→ For operation details on GX Configurator-DP, refer to
→ For examples on setting parameters and configurations, refer to Chapter 8
the GX Configurator-DP Software Manual
1
2
3
4
5
6
7
8
9
51
Advertisement
Table of Contents
