Table of Contents
Advertisement
FX
-32DP PROFIBUS-DP Interface Block
3U
User's Manual
7.1
Slave Parameter Settings
The slave parameters for the 32DP must be set using the DP-Master Configuration Tool. This section
describes the available parameters that are available with GX Configurator-DP.
7.1.1
Slave Properties
Set the following parameters in the Slave Properties section of the "Slave Paramenter Settings" dialog box
within GX Configurator-DP.
→ For details on the "Slave Parameter Settings" dialog box, refer to the GX Configurator-DP Software
Parameter
Name
FDL address
Watchdog
Slave Watchdog
Time
min T_sdr
Group
Identification
Number
Slave is active
Sync (Output)
Freeze (Input)
Swap I/O Bytes
in Master
DP V1/V2 Slave
Parameters
7.1.2
Extended User Parameters
Use the "User Param." button from the "Slave Parameter Settings" dialog box in GX Configurator-DP to
enable or disable the swap byte order. The default setting is set to "disable." The "User Param." button
opens the "Extended User Parameters" dialog box and is applicable for the Byte Swap of cyclic/acyclic I/O-
Data.
52
Name of the DP-Slave
This item defines the slave address
Check off to enable the watchdog control for the DP-Slave
The
DP-Slave
monitors
communication process within the preset watchdog time, and if the
process exceeds the watchdog time, BFM #29 Bit 8 turns ON
Here, users need to set the watchdog time interval of the DP-Slave
when the watchdog functionality is enabled.
The Watchdog Time must be longer than the max. PROFIBUS Cycle
Time.
→ For details on PROFIBUS Cycle Time, refer to
This is the minimum response time for a DP slave to send the
response frames to the DP master. Do not change this value.
Check off to allocate the DP-Slave to a group or a set of groups.
The DP-Slaves in the same group operate synchronously
Check off for the master to determine the presence of the specified
DP-Slave
This helps users sort out the physical network connections
Check off set the output data ready for the SYNC mode
Check off to set the input data ready for the FREEZE mode
Check off to swap the byte order for a PROFIBUS DP Module having
the reversed-byte word format
Click this button to open the <DP V1/V2 Slave Parameters> dialog
box. Use the options to enable/disable DP-V1 Support and to set
support for Diagnostic Alarm data. The default setting for "DP V1
support enabled" is "Not checked"
7 Parameter Setting and Network Configuration [GX Configurator-DP]
→ For details on the "Slave Parameter Settings" dialog box,
refer to the GX Configurator-DP Software Manual.
Description
if
the
DP-Master
completes
the respective DP-Master Manual
→ For details on the "Slave Parameter Settings" dialog box,
refer to the GX Configurator-DP Software Manual.
7.1 Slave Parameter Settings
Manual.
Default/Setting Range
Default: Slave_Nr_001
Default: 1
Range : 0 to 125
the
Default: Not Checked
Range: 1 to 65025 [10ms]
Default : 11
Range : 1 to 255
−
Default : Checked off
Default : Not Checked
Default : Not Checked
Default : Not Checked
−
Advertisement
Table of Contents
