Table of Contents
Advertisement
Next is the installation of the spool holder. Install one on each side.
The installation of the spool holder is very simple – just insert it into the circular opening and tighten the nut behind.
Then install the
filament guide tube
to the empty spot on the extruder. Place one end of the guide tube into the hole.
The hardware installation is almost complete.
Next, with the power switch in the
OFF
position, confirm that the power cord is plugged into the power outlet next to
the power switch.
Now plug the
USB A to B cable
into the USB B-type port, do not plug the other end in yet.
Finally install the filament on the
spool holder.
６
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Creator Pro and is the answer not in the manual?
Questions and answers