What's Included In The Box; Un-Boxing - FLASHFORGE 3D PRINTER Creator Pro Startup Manual

1

What's Included in the Box?

Along with your Creator Pro 3D printer, the box also contains the following:
In the two long boxes on the top of the package, you'll find:
 Power cord x 1pc,
 USB A to B cable x 1pc,
 Sensor Line x 1pc,
 Filament guide tube x 2 pcs.
 Filament spool holder x 2 pcs.
In the Creator Pro Acrylic Accessory box:
Acrylic sheet x6 pc
●
Handle x1 pc
●
Accessory bag x1 pcs
●
An accessory box on the top of the Creator Pro:
 Dual extruder heads x 1pc,
 4G SD card x 1 pc,
 Blue tape x 1 pc,
 Bolt, hex wrench and screws kit x 1 bag.
Under Creator Pro's build platform, there are 2 rolls filament:
 White ABS filament x 1kg (2.2pounds),
 Blue PLA filament x 1kg (2.2pounds),
2

Un-boxing

The Creator Pro was carefully packaged at FLASHFORGE manufacturing facility. Please follow the unboxing steps laid
out below.
CAUTION
Handle the package and its contents with extra care; do not use any unnecessary force.
Do not remove the
adhesion of the extruded plastic to the plate.
Do not remove the wrapping around the nozzle. It consists of a ceramic fiber fabric and heat resistant

tape that helps to keep the nozzle at a constant temperature.
First, put the box on the floor in a clean and flat surface. Remove the top two long boxes and set them aside. You will
find a power cord, 1 USB A to B cable, 1 sensor line and 2 filament guide tubes
thin yellow film from the heating plate. It is heat resistant tape that improves the
in these two long boxes.
２