Table of Contents
Advertisement
You will find another box within the relevant assembly tools under the two long boxes. You should assemble the Acrylic
cover yourself and please check the assembly video in the SD card.
Please hold both sides of the printer and take it out after you take out the side EPE of Creator Pro.
Please make sure
you only can hold the frame.
Now you can see the top of the printer along with more boxes inside. The large box with the black wire is the
accessory
box. This contains the
dual extruder heads, SD card and other important
components. Don't remove the
accessory box or its contents yet.
Note: Do not lift the box by the black cable! If so could cause damage.
Next, take the Creator Pro out of the box by grasping the outer frame.
Be sure to grasp only the frame.
Gently lift and
transfer the printer to your work surface as shown on next page.
Gently lay down the printer and open the bubble film as shown below.
３
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Creator Pro and is the answer not in the manual?
Questions and answers