Withdrawing The Filament Using Lcd Screen; Feeding The Filament Using Replicator G Control Panel - FLASHFORGE 3D PRINTER Creator Pro Startup Manual

Feed operation with LCD screen
4. Select Filament
Load Right
▶
Unload Right
Load Left
Unload Left
5. Select the appropriate side of the extruder you wish to load(Left or Right for models with dual extruders).
Press the OK key
temperature of the right nozzle is being heated up. When the temperature of the nozzle reaches its target
temperature, pressing the
pressing the OK key
6.3

Withdrawing the Filament Using LCD Screen

CAUTION
If you just finished your printing or already extruded the filament and want to withdraw the filament, at this
moment, the extruder is still over 200°C, first push the filament in a little further, and then directly pull it out.
If you want to change another color filament, first you need to withdraw filament and then load in. Please
do as following shown to avoid filament jam.
1) Turn on the Creator Pro, the display will indicate:
Build from SD
Preheat
▶
Utilities
2) Using the directional arrows to the right of the screen, press
select Preheat, Press
Start Preheat
▶
Right Tool
Left Tool
Platform
3) Press page down key
Start Preheat
▶
Right Tool
Left Tool
Platform
4) Press page up key
Heating:
R Extruder: 033/230C
L Extruder: 033/230C
Platform: 024
This means the left extruder is heating up, when it reaches 220°C. First
filament come out of the
nozzle successfully.
6.4

Feeding the Filament Using Replicator G Control Panel

The following can only be performed while the printer is connected to the computer.
Open the Replicator G software, click the icon in the red box, this is the control panel icon. The dialogue box shown
below will then pop up.
loading; press the OK key
again on the keypad. The display will indicate: I'm heating up my extruder!" At this time, the
OK key on the keypad, and the nozzle should start extruding material. If not, keep
unit it does.
OK key on the keypad, then you will see：
OFF
OFF
OFF
to select Left Tool (or Right
ON
ON
OFF
back to Start Preheat, and Press
nozzle, then pull it out
of the keypad. The display will show:
page down key
Tool), click OK key, you will see：
OK key, you will see:
push in
quickly. This will ensure you have withdrawn the filament inside the
to scroll to the next page and
the filament a little bit until you see
１７