Quick Entry Map; Quick Entry Map Table Of Contents - IBM RS/6000 7043 43P Series Service Manual

Quick Entry MAP

Use the following table to determine your starting point in the Entry Map.

Quick Entry MAP Table of Contents

Problem Description
Service Actions
System Stops or Hangs with Alternating Numbers Displayed in the Operator
Panel Display
System Stops With an Error or Checkpoint Code Displayed
There Appears to be a Display Problem (Distortion, Blurring, etc.)
Power and Cooling Problems
Other Symptoms or Problems
You Cannot Find the Symptom in this Table
Use the following table to determine your starting point.
Symptom
You have parts to exchange or a corrective
action to perform.
You need to verify that a part exchange or
corrective action corrected the problem.
You need to verify correct system operation.
System Stops or hangs with alternating numbers displayed in the Operator Panel display.
The Operator Panel display alternates between
the code "E1FD" and another "Exxx" code.
The Operator Panel display alternates between
the codes "E1DE" and "E1AD".
System Stops With an Error or Checkpoint Code Displayed
The system stops and an 8-digit error code
starting with the character "M" is displayed.
2-2
7043 43P Series Service Guide
Action
Service Actions
1. Go to Chapter 8, "Removal and
Replacement Procedures" on page 8-1.
2. Go to "MAP 0410: Repair Checkout" in the
Diagnostics Information for Multiple Bus
Systems.
Go to "MAP 0410: Repair Checkout" in the
Diagnostics Information for Multiple Bus
Systems.
Go to "MAP 0410: Repair Checkout" in the
Diagnostics Information for Multiple Bus
Systems.
Record both codes. Go to the entry for "E1FD"
on page 4-24.
Record the error codes. Go to the entry for
"E1DE" on page 4-22,
Record the error code. Go to "POST Error
Codes" on page 3-2.
Page No.
2-2
2-2
2-2
2-3
2-4
2-4
2-6