Chapter 4. Error Code To Fru Index For The Model 150; Error Codes - IBM RS/6000 7043 43P Series Service Manual

Chapter 4. Error Code to FRU Index for the Model 150

Note: This chapter contains error code and checkpoint information for the Model
150 only. For information on the Model 140 and Model 240, refer to
Chapter 3, "Error Code to FRU Index for the Model 140 and Model 240" on
page 3-1.
If you replace FRUs and the problem is still unresolved, go to "MAP 1540: Minimum
Configuration" on page 2-21, unless otherwise indicated in the tables. If you replace
FRUs and the problem has been resolved, go to "MAP 0410: Repair Checkout" in
the Diagnostics Information for Multiple Bus Systems, unless otherwise indicated in
the tables.

Error Codes

The error codes listed in Table 4-1, in most cases, identifies the failing device/FRU.
Refer to Appendix A, "Interpreting Firmware Error Codes" on page A-1 for
information on interpreting 8-digit error codes. A physical location code may be
displayed with the error code. If so, use the physical location code to identify the
suspected FRU.
Table 4-1 (Page 1 of 11). Firmware Error Codes
Error Code Function /
Description
Remote Initial program load (RIPL) errors
20A80000 Insufficient
information to boot
20A80001 Client IP address is
already in use by
another network
device
20A80002 Cannot get gateway
IP address
20A80003 Cannot get server
hardware address
20A80004 Bootp failed
20A80005 File transmission
(TFTP) failed
20A80006 Boot Image Too
Large
Unknown/Unrecognized device
Repair Action/Possible Failing FRU
Verify the IP address
Change IP address
Refer to Firmware Checkpoints using code E174
Refer to Firmware Checkpoint using code E174
Refer to Firmware Checkpoint using code E175
Check network connection, try again.
Contact your service representative for assistance.
Chapter 4. Error Code to FRU Index for the Model 150
4-1