IBM RS/6000 7043 43P Series Service Manual page 101

Table 3-2 (Page 2 of 9). Firmware Error Codes.
Error Code Description
003 Power on Password must be set for
Unattended mode
004 Battery drained or needs replacement
005 EEPROM locked
008 CMOS corrupted or tampering evident,
CMOS initialized
009 Invalid password entered - system
locked
00A EEPROM lock problem
00B EEPROM write problem
00C EEPROM read problem
017 Cold boot needed for password entry
20EE0xxx Informational
xxx=003 SMS: Invalid RIPL IP address (requires
3 dots ".")
Chapter 3. Error Code to FRU Index for Model 140 and Model 240
Action/
Possible Failing FRU
Unattended mode requires the setting
of the Power On password before can
be enabled.
1. Replace battery.
2. Replace system board. (See notes
on page 3-1.)
1. Turn off, then turn on system unit.
2. Replace the system board. (See
notes on page 3-1.)
Check your machine for evidence of
tampering.
If no tampering evident:
1. Replace battery, restore NVRAM
data (passwords, startup data)
2. Replace system board. (See notes
on page 3-1.)
The password has been entered
incorrectly 3 times.
Turn off, then turn on the system unit,
then enter the password correctly.
If for priviliged-access password install,
is jumper in correct position?
Consult the system's User's Guide for
jumper location and position.
1. Turn off, turn on system unit.
2. Replace system board. (See notes
on page 3-1.)
1. Turn off, turn on system unit.
2. Replace system board. (See notes
on page 3-1.)
1. Turn off, turn on system unit.
2. Replace system board. (See notes
on page 3-1.)
Turn off, turn on system unit.
Enter valid RIPL IP address.
Example: 000.000.000.000
3-5