Test Run - Grizzly G9729 Instruction Manual

Test Run

Inspect your machine for
loose nuts and bolts, and
ensure no tools are left
in or around the machine
before connecting power.
Failure to do this may
result in personal injury.
Keep
up and out of the way
of machinery and keep
hair pulled back.
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
Wear safety glasses dur-
ing all operations on the
lathe/mill.Failure to com-
ply may result in serious
personal injury.
-18-
clothing rolled
Now that the lathe/mill is set up and you have
read the safety guidelines, it's time to give each
motor a test run.
The purpose of the test run is to make sure the
lathe/mill is wired correctly and the motors are
working properly before proceeding with addi-
tional set up. Check to make sure that auto feeds
are not engaged, the chucks are secure in the
spindles, and there are no loose parts around
the spindles. Set the lathe/mill to the slowest
RPM before the test run. Refer to Control Panel
on Page 19, Lathe Speeds on Page 34, Mill
Speeds on Page 44, and Lubrication on Page
51 before doing the test run.
The lathe and mill motors will be tested inde-
pendently. Before starting the lathe/mill:
1.
Make sure the machine is properly ground-
ed, the power switch is turned OFF, and
both reversing switches are set to the middle
position.
2.
Inspect the machine to ensure that all hand
tools are out of the way, guards are in place
and nothing is impeding the movement of
either chuck. Check this by rotating each by
hand.
3.
Rotate the EMERGENCY STOP button in
the direction of the arrows on the button and
allow it to pop out.
4.
Push the START button on the control panel.
While keeping your hand on the reversing
switch for the lathe, turn it to the FORWARD
position. The lathe should run smoothly with
little or no vibration or rubbing noises when it
starts. Strange or unnatural noises should be
investigated and corrected before operating
the machine further.
5.
If the lathe/mill is running correctly, turn the
reversing switch to the OFF position, wait for
the machine to come to a complete stop.
G9729 Combination Lathe/Mill