Lubrication - Grizzly G9729 Instruction Manual

Lubrication

Your Model G9729 will function best when it is
clean and well lubricated. Take the time to wipe
down and oil the machine before each use. We
recommend using ISO 68 or SAE 20W non-
detergent oil unless otherwise specified. Ball fit-
tings will require the use of an oil gun. Press the
ball with the tip of the gun and squirt a little oil
under pressure. Wipe the ball fitting before and
after each use to prevent contamination.
Apron and Cross Slide: Apply lubrication direct-
ly to the dovetail ways of the apron and cross
slide.
Figure 68. Oil ports indicated by arrows.
Compound: This slide is supplied with ball fit-
tings on its top surface and should be oiled at the
same time as the apron (Figure 68).
G9729 Combination Lathe/Mill
-51-