Inventory - Grizzly G9729 Instruction Manual

Inventory

After all the parts have been removed from the
two boxes, you should have the following items:
Box 1: (Figure 3)
A. Model G9729 Combo Lathe/Mill ................. 1
B. Face Plate .................................................. 1
C. Adaptor Plate .............................................. 1
Small Box Contents:
D. 120T/127T Combo Gear, & 72T Gear ....... 1
E. 36T Gear, & 33T Gear ............................... 1
F.
30T Gear, & 27T Gear ............................... 1
G. 60T Gear, & 48T Gear ............................... 1
H. 42T Gear, & 39T Gear ............................... 1
I. Plastic Spindle Cover ................................. 1
J. Lathe Chuck Jaws ...................................... 1
K. Leadscrew Crank Handle ........................... 1
L. Wrench 13/16mm ...................................... 1
Flat Head Screwdriver ................................ 1
Drift ............................................................. 1
Hex Wrench 3, 4, 5, & 8mm ....................... 4
M. MT#4 Dead Center ..................................... 1
N. MT#3 Dead Center ..................................... 1
O. Lathe Chuck Key ........................................ 1
Tool Post Wrench ....................................... 1
Shims ......................................................... 3
Drill Chuck Key ........................................... 1
Item not shown:
P. Hex Handle 14mm for Head Lock .............. 1
-12-
Qty
D
E
F
Figure 3. Model G9729 Inventory.
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
A
I B
C
G
H
J
K L
G9729 Combination Lathe/Mill
M
N
O