Hand Crank; Handwheels - Grizzly G9729 Instruction Manual

Hand Crank

The hand crank for the longitudinal manual feed
must be installed.
To install the hand crank:
1. The end of the leadscrew has a washer and
screw attached. Remove these.
2.
The hand crank has a key slot on one side
as shown in Figure 6. Slide the hand crank
onto the end of the leadscrew, key slot first.
3.
Thread the screw through the washer and
into the end of the leadscrew.
4.
To use the hand crank, push it in towards the
leadscrew so the key way and key engage.
Turn the hand crank while keeping pressure
applied. When released, the hand crank will
withdraw from the leadscrew and will no lon-
ger be engaged.
Key Slot
Figure 6. The key is engaged with the hand
crank.
-16-

Handwheels

The apron and cross slide handwheel handles
must be installed. A screwdriver is supplied for
this job. Locate the threaded holes on each hand
wheel and attach the handles (see Figure 7).
Figure 7. Attach handles to handwheels.
G9729 Combination Lathe/Mill