Communications Transmit (Xmt) Selection - PS Engineering PDA360EX Pilot's Manual And Operation Manual

ity in a very logical manner.
Press the line select key to
select a specific item on
each menu. Items are tog-
gled on and off by pressing
the line select key as well.
The menu screen will auto-
matically return to this
"home" screen after a period of inactivity. This delay is configurable
for 1 to 30 seconds, on the initialization menu. A long press of the
button will back-up one menu level.
A split bar indicates that a secondary function is available when that
button is held for more than 1 second.
A vertical bar next to a button, indicates the button can perform a
function on that menu.

Communications Transmit (XMT) Selection (2)

The PDA360EX has four buttons to select com-
munications transceiver functions, two each C1
and C2. C1 refers to VHF COM 1, and C2, to
VHF COM 2. To select a VHF COM for transmit;
push the lower button in the XMT (transmit) sec-
tion. The radio is automatically selected to receive
incoming radio calls when the XMT is selected.
With a PDA360EX, you will never transmit on a
radio that you are not receiving.
To select a VHF COM radio to listen only, push
the C1 or C2 button in the RCV (Receive) section.
The PDA360EX will remember when you have selected a radio for
receive only, and then switch to it for transmission and switch back to
receive only.
Split Mode
In the SPLIT mode, the pilot position trans-
mits and receives on COM 1, and the copilot
can transmit and receive on COM 2 inde-
pendently.
Pressing the C1 and C2 XMT buttons to-
gether (above the └SPLIT┘ legend), puts the
PDA360EX into SPLIT com mode.
Oct. 2015 PDA360EX Pilot Guide 202-360-0000 Page 3