Chapter 5 Network Commands; Snmp Commands; Add Community; Add Trap - Perle IOLAN CSS Cli Reference Manual

5
This chapter defines all the CLI commands associated with configuring the IOLAN's network
parameters.

SNMP Commands

Add Community

Description Adds an SNMP community (version 1 and version 2).
User Level Admin
Syntax
Options

Add Trap

Description Adds an SNMP host to which trap messages will be sent. The IOLAN supports SNMP
User Level Admin
Syntax
Options
Network Commands
add community <community_name> <config_host>|<IP_address>
none|readonly|readwrite
<community_name>
The name of the group that devices and management stations running SNMP belong to.
<config_host>|<IP_address>
The host name of the SNMP community that will send requests to the IOLAN.
The IPv4 or IPv6 address of the SNMP manager that will send requests to the IOLAN.
If the address is
0.0.0.0
the IOLAN. If you specify a network address, for example
manager within the local network with the
none|readonly|readwrite
Permits the IOLAN to respond to SNMP requests by:
None—There is no response to requests from SNMP.
Readonly—Responds only to Read requests from SNMP.
Readwrite—Responds to both Read and Write requests from SNMP.
traps for restart and SNMP community authentication error.
add trap <trap_name> <config_host>|<IP_address>
<trap_name>
The trap receiver is the network management system (NMS) that should receive the
SNMP traps. This NMS must have the same SNMP community string as the trap
sender.
<config_host>|<IP_address>
Defines the hosts (by IPv4 or IPv6 address) that will receive trap messages generated by
the IOLAN. Up to four trap hosts can be defined.
IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6
, any SNMP manager with the
Community Name
can access
Community Name
, any SNMP
172.16.0.0
can access the IOLAN.
Chapter 5
101