Table of Contents
Advertisement
Place the carrier on its feet towards the back of
9
the shelf or desk, making sure it is in a stable
position. Be sure the telephone line cords come out the
rear exit slots in the back of the unit. Arrange the power
cord and telephone line cords beneath the shelf or
desk so no one can step on them or trip over them.
Insert the carrier's power cord into the AC
10
adapter, then plug the AC adapter into a
properly grounded 3-prong wall outlet that is not
controlled by an on/off switch.
If appropriate, you can wall mount the AC adapter
using its attached wall-mounting bracket.
CAUTION:
Never connect or disconnect telephone line
cords, or insert or remove radio modules,
while the carrier is plugged into the wall
outlet.
Verify that the carrier's Out of Sync light is not
11
lit. If the light is lit, power down and then
repower the carrier. If the light is still lit, call for help
as described on the inside front cover of this booklet.
2-16
Installing the MDW 9010
Go to "Installation Self-Test."
Advertisement
Table of Contents
