Table of Contents
Advertisement
Regulatory Information
This appendix contains information about the Federal Communications Commission and
Industry Canada.
FCC Part 15 Rules
The AT&T MDW 9010 Wireless Pocketphone has been tested and has been found to comply with
FCC Part 15 Rules. These specifications are designed to provide reasonable protection against
harmful interference in a commercial or residential installation. This wireless telephone gener-
ates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If the telephone does
cause harmful interference to radio or television reception, which can be determined by turning
the telephone off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Where it can be done safely, reorient the receiving television or radio antenna.
To the extent possible, relocate the television, radio, or other receiver with respect to
the telephone.
Plug the telephone into an electrical outlet that is not on the same circuit as one used
by the radio or television
IC RSS-210 Compliance
This device complies with RSS-210 of Industry Canada. Operation is subject to the
following two conditions:
1.
This device may not cause interference.
2.
This device must accept any interference including interference that may cause
undesirable operation of the device.
The user is cautioned that modifications to this telephone, not expressly approved by
AT&T, could void the user's authority to operate the equipment.
Hearing Aid Compatibility
This wireless telephone is compatible with inductively-coupled hearing aids.
B
Regulatory Information
B-1
Advertisement
Table of Contents
