Radio Modules And Carriers - AT&T MDW 9010 Installation And Use Manual

Radio Modules and Carriers

This section explains how to install radio modules and carriers. You should proceed
through this section in the following order:
1. "Key Components"
2. "Positioning a Single Radio Module or Carrier(s)"
3.
Choose one of the following paths, depending upon which components you are
installing:
If you are installing a single radio module, go to
"Installing a Single Radio Module."
If you are installing a single carrier, go to
a. "Setting the Power Level." Then go to either
b . "Installing a Single Carrier on a Shelf or Desk" or
"Installing a Single Carrier on a Wall."
If you are installing multiple carriers, go to all of the following:
a. "Setting the Power Level" then
b. "Setting the Control/Expansion DIP Switch" then
c . "Installing Multiple Carriers."
4. "Installation Self-Test"
NOTE:
The illustrations in this chapter depict PARTNER system hardware; your hardware may
differ from these illustrations.
2-4
Installing the MDW 9010