Table of Contents
Advertisement
Additional Safety Instructions
for Installation Personnel
Install the product to meet all environmental and electrical requirements listed in
Appendix C.
All wiring that connects to this equipment and becomes part of the building wiring
must be a minimum of CLASS 2 or U.L. Listed Communications cable.
Do not install telephone wiring during a lightning storm.
Do not install telephone jacks in a wet location unless the jack is specifically designed
for wet locations. Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Install this product securely on a stable surface. Damage may result if the product
falls.
Never place this product near or over a radiator or heat register.
Slots and openings in the housing and the back or bottom are provided for ventilation.
To protect the housing from overheating, these openings must not be blocked or
covered. Therefore, do not place the product on a bed, sofa, rug, or other similar
surface. Also, do not place this product in an enclosed area unless proper ventilation
is provided.
Install this product in a protected location where no one can step on or trip over power
cords and telephone line cords. Do not place objects on the cords that may cause
damage or abrasion.
Do not allow anything to rest on the power cord. Do not locate this product where the
cord will be abused by persons walking on it. Do not overload wall outlets as this can
result in the risk of fire or electric shock. Do not staple or otherwise attach the power
cord to building surfaces.
Use only the Model # PIDB-270 power supply shipped with this product for the battery
charger or radio module.
Use only the Model # SW109 power supply shipped with the carrier.
Use only the correct power source. If you are not sure of the power supply to your
location, consult your local power company.
This product uses a 3-prong plug in continental U.S. locations. Such plugs are de-
signed for your safety. Do not attempt to defeat this purpose. If your wall outlet will not
accept the plug, the outlet should be replaced by an electrician.
Use only the type of battery pack shipped with this product.
2-2
Installing the MDW 9010
Advertisement
Table of Contents
