Unloading The Cabinet(S); Three-High Cabinets Or Two-High Ebms - Eaton 9355 User Manual

UPS Setup

Unloading the Cabinet(s)

The following tools are required for unloading the cabinet(s):
15 mm wrench or socket
l
7 mm nut driver or socket
l
The UPS and EBM are heavy (see page 7). Unloading the cabinets requires at least two people to safely
remove the cabinets from the pallet.
To unload three-high cabinets or two-high EBMs, continue to the following section. To unload two-high UPS
cabinets, proceed to page 11.

Three-High Cabinets or Two-High EBMs

To remove a three-high cabinet or a two-high EBM from the shipping pallet:
1. Remove the two M10 bolts securing the stabilizing bracket to the pallet (see Figure 2).
Figure 2. Removing the Stabilizing Bracket Bolts
2. Remove the M10 bolts from the two Pallet Brackets securing the leveling feet to the pallet (see Figure 3).
3. Remove the four M4 screws securing the stabilizing bracket to the cabinet rear panel and remove the
bracket (see Figure 3). Retain the hardware for later use.
Note: Retain the stabilizing bracket and hardware for later re-assembly onto the cabinet.
4. Remove the front cover from the bottom cabinet to access the front shipping bracket.
Press and release the handle latch at the bottom of the cover and then lift the cover up and off the cabinet.
5. Remove the three M10 bolts securing the rear shipping pad to the pallet and remove the shipping pad.
8 Eaton 9355 UPS (10/15kVA) User's Guide 164201594—Rev G
CAUTION
M10 Bolts
www.eaton.com/powerquality