Lansafe Power Management Software - Eaton 9355 User Manual

1. Verify that the UPS is turned off and all power sources are removed.
2. Install wiring from the IRC to the monitoring equipment using 1/2" conduit through the cable exit opening
in the IRC (see Figure 57).
3. Connect wiring between the IRC and the monitoring equipment using terminations shown in Table 6. See
Figure 56 for plug–in terminal block locations.
4. Install the IRC into an open X-Slot communication bay (see Figure 48 page 50).
5. To check the operation of the IRC, ensure that the UPS is supplying the load via the inverter or bypass. If
the indicators on the customer's monitoring equipment show the appropriate status, then it is operating
correctly.
If the IRC is not operating correctly, check the wiring, the fuse on the IRC, and the plug–in terminal blocks
for proper seating. If all connections are secure but the IRC still does not operate correctly, replace the
fuse. If this does not correct the problem, contact your service representative for verification that the IRC
is working correctly.
Table 6. IRC Wire Terminations
IRC Terminal
J2-1
J2-2
J2-3
J2-4
J2-5
J2-6
J2-7
J2-8
J2-9
J2-10
J2-11
J2-12
Maximum contact rating: 250 Vac, 30 Vdc @ 5A; Wire range: 1624 AWG

LanSafe Power Management Software

Each Eaton 9355 UPS ships with LanSafe Power Management Software and an interface cable. To begin
installing LanSafe software, see the instructions accompanying the Software Suite CD.
Note: Use only the supplied communication cable to connect the UPS to your computer.
LanSafe software provides up-to-date graphics of UPS power and system data and power flow. It also gives
you a complete record of critical power events, and it notifies you of important UPS or power information. If
there is a power outage and the Eaton 9355 UPS battery power becomes low, LanSafe software can
automatically shut down your computer system to protect your data before the UPS shutdown occurs.
Function
NC
COM
NO
NC
COM
NO
NC
COM
NO
NC
COM
NO
Eaton 9355 UPS (10/15kVA) User's Guide 164201594—Rev G
Remarks
Normal mode
Bypass mode
Battery mode
Alarm mode
www.eaton.com/powerquality
Communication
57