IDTECK 100RV User Manual page 55

Problem
I lost the Master Card and could
not register or delete the card or
change the settings.
100RV can recognize a presented
RF card but can not recognize the
RF card number using the keypad.
Action
√ For more information about deleting the user card,
refer to the user deletion section in the user manual.
- If you have lost the Master Card (or PIN)
III. Registering or deleting the user card is not possible
without the Master Card
IV. Initializing the product
√ For more information about initializing the
product, refer to the initialization section in the user
manual.
2. If the problem persists after you have followed the
procedures above, contact a designated service center.
1. You must initialize the product if you want to change the
device settings without the Master Card (or PIN).
(Initializing the product will restore all your settings
regarding the Master Card and user cards to the factory
default.)
I. Initialization using the external cable
√ Turn off the product and detach it from the wall.
√ Connect the orange line of the product to the
orange line with the white stripes.
√ Turn on the product and check the initial state
(LED indicators blink with the increasing bell sound)
√ Disconnect the two short-circuited lines and turn
off the product
2. If the problem persists after you have followed the
procedures above, contact a designated service center.
1. Check if the buzzer sounds when you press a key.
- If you hear the buzzer sound
I. Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) +
ENT)
II. Enter the command to enable the keypad input: 73 +
ENT
III. For more information, refer to the section of
enabling or disabling the keypad input for a card
number in the user manual.
- If you hear the buzzer sound after a certain time
IV. The keypad input will be suspended for one minute
(default) if you enter unregistered numbers in 5
consecutive times (default).
p.50
100RV
Troubleshooting