Basic Setup; Duress Alarm; To Specify The Retry Count For An Unregistered Id - IDTECK 100RV User Manual

Basic setup

1

DURESS alarm

If you are forced to open the door under the control of a criminal such as a robber, enter the
predefi ned password with the number of your registered card (or PIN), which outputs the
emergency TTL signal.
1. Present the Master Card to the device.
2. Press Button
3. Enter the two-digit Duress code and press .
• The default code is set to "00". However, the number "77" can not be used because it
is set for the Secure mode.
2

To specify the retry count for an unregistered ID

You can specify the retry count for authentication with an unregistered card or PIN.
If the retry count exceeds the set limit, the keypad input will be suspended for the next one
minute. (You can specify the keypad input suspension time in "To specify the keypad input
suspension time if the retry count with an unregistered ID exceeds the limit" on page 24.)
1. Present the Master Card to the device.
2. Press Button
3. Enter the two-digit retry count and press
• You can specify a number from 00 to 99.
and Button in sequence and press
and Button in sequence and press
.
.
.
p.24
7