Reader Mode Setup (Rf/Pin Combination Mode); Enabling Keypad Input For The Card Number - IDTECK 100RV User Manual

Repeat the step above if you want to register PIN numbers with the device in sequence.
If you don't want to register the PIN number right now, simply jump to Step 5 above
without through Step 4 above.
5. Enter the 4-6 digit Master PIN number again and press
6. The device enters Standby mode with only the orange LED indicator flashing.
4

Reader mode setup (RF/PIN combination mode)

No Master Card or Master PIN is ever registered.
If you remember the Master Card or the Master PIN was registered, initialize the product
and try again.
1. When you turn on the product, all of the 3 LED indicators will flash with a beep.
• No flashing of the 3 indicators denotes that the reader mode is already specified.
2. Press
3. Present a card that you want to register as the Master Card to the device.
When the Master Card is registered, only the red LED indicator flashes.
4. Present cards or PIN numbers (4-6 digits) to register with the device one after another,
and the device will register them with a beep. If you don't want to register the cards
right now, simply jump to Step 5 above without through Step 4 above.
5. Present the registered Master Card to the product once again.
6. The device enters Standby mode with only the orange LED indicator flashing.
5

Enabling keypad input for the card number

Ensure that you must have registered the Master Card.
1. Press
2. Repeat Step 1 above to release the specified mode, press
Reader mode setup
Button and Button in sequence and press
Button and Button in sequence and press
.
p.19
100RV
.
.
Button and Button