IDTECK 100RV User Manual page 54

Problem
The user card (or PIN) is not
deleted.
Troubleshooting
Action
according to the operation mode
√ RF Only : 11 + ENT
√ RF + P/W : 12 + ENT
√ PIN Only : 13 + ENT
√ RF or PIN : 15 + ENT
III. Enter the user card or PIN number and provide the
password according to the mode
IV. Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) +
ENT)
√ For more information about registering the user
card, refer to the additional user registration section
in the user manual.
3. If the problem persists after you have followed the
procedures above, contact a designated service center.
Check the operation status of the product
1. Check if the product works properly.
- If the product operates normally (and you have the
Master Card or the PIN number)
I. If you have the card to delete
√ Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or
05) + ENT)
√ Enter the command to delete the user: 14 + ENT
√ Enter another card to delete (if you have multiple
cards to delete)
√ Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or
05) + ENT)
II. If you have lost the card to delete. But you know the
card number
√ Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or
05) + ENT)
√ Enter the command to enable the keypad input:
73 + ENT
√ Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or
05) + ENT)
√ Enter the command to delete the user: 14 + ENT
√ Enter another card to delete and press ENT (if you
have multiple cards to delete)
√ Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or
05) + ENT)
p.49
100RV