IDTECK 100RV User Manual page 53

Problem
The product just switches to
normal operation mode while I
am registering a user in a set
mode or configure the settings.
I can not register an additional
user card (or PIN).
Action
II. If the problem persists, perform the initialization
process for the next step.
√ For more information about initializing the
product, refer to the initialization section in the user
manual.
III. If the problem persists after you have followed the
procedures above, contact a designated service
center.
1. If no key input is entered within 20 seconds in a set mode,
the product will switch to normal operation mode
automatically. (normal operation)
1. Check if the product is installed properly and works
normally.
- In the initial setup of the product or after it is initialized
Set the operation mode and register the Master card and
user cards as usual because the product is in the initial
state.
I. 100RV modes available : Mode Number + ENT
√ RF Only : 01 + ENT
√ RF + P/W : 02 + ENT
√ PIN Only : 03 + ENT
√ RF or PIN : 05 + ENT
II. Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) +
ENT)
III. Enter the user card or PIN number and provide the
password according to the mode
IV. Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) +
ENT)
√ For more information about registering the Master
Card and the user card, refer to the initial setup
section in the user manual.
2. If this happens when you try to register an additional card
in normal operation mode
- Register the user card only as the Master Card is already
registered.
I. Master Card (or (PIN): 4 ~ 6 digits (Mode 03 or 05) +
ENT)
II. Command for an additional card registration
p.48
100RV
Troubleshooting