H3C S7500E Series Configuration Manual page 67

Configure WRR Queuing
Configuration procedure
Follow these steps to configure group-based WRR queuing:
To do...
Enter system view
Enter
interface
view or port
group view
Enable WRR queuing
Configure a WRR queue
Display WRR queuing
configuration information
Configuration example
1) Network requirements
Enable WRR queuing on the interface GigabitEthernet 2/0/1.
Assign queues 0 through 7 to the WRR group, with their weights being 1, 3, 3, 5, 8, 8, 10, and 15.
2) Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure WRR queuing on GigabitEthernet 2/0/1.
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] qos wrr
[Sysname-GigabitEthernet2/0/1] qos wrr 0 group 1 weight 1
[Sysname-GigabitEthernet2/0/1] qos wrr 1 group 1 weight 3
[Sysname-GigabitEthernet2/0/1] qos wrr 2 group 1 weight 3
[Sysname-GigabitEthernet2/0/1] qos wrr 3 group 1 weight 5
[Sysname-GigabitEthernet2/0/1] qos wrr 4 group 1 weight 8
[Sysname-GigabitEthernet2/0/1] qos wrr 5 group 1 weight 8
[Sysname-GigabitEthernet2/0/1] qos wrr 6 group 1 weight 10
[Sysname-GigabitEthernet2/0/1] qos wrr 7 group 1 weight 15
Configuring WFQ Queuing
Configuration procedure
Follow these steps to configure an WFQ queue:
system-view
Enter
interface interface-type
interface
interface-number
view
Enter port
port-group manual port-group-name
group view
qos wrr
qos wrr queue-id group 1 weight
schedule-value
display qos wrr interface
[ interface-type interface-number ]
Use the command...
6-6
Remarks
—
Use either command
Settings in interface view take
effect on the current interface;
settings in port group view take
effect on all ports in the port group.
Optional
The default queuing algorithm on
an interface is SP queuing.
Required
Optional
Available in any view